LINE LASER

UD Series

The LAP UD Laser best performs near your workpiece.

 

UD LASER: LOW MOUNTING SPECIALIST

Diode lasers of LAP UD Series are designed for installation low above the working surface. The UD series was the answer on customers requests for a laser with small housing like LD series, line length and quality of ULTRALINE to be built in low above working level. The main target for UD lasers are veneer- or sheet metal shears, as well as any place where you have little headroom but you need a long line, starting directly below the laser.
You need a 4 m line, you only have 20 cm of height and the laser must be installed on one side of the opening? Then you need a UD laser!

  • Small housing
  • Extremely low mounting position
  • Special optics for laser line with
    homogeneous brightness distribution
Typical applications

Veneer
Textiles

Typical tasks

Projection of line

Compare devices

Compare

Compare devices with each other and find the optimal solution for you. Then adjust your device to your requirements in the Configurator.

TECHNICAL DATA

MODEL DATA

Line lasers

Models Laser power Line length* Laser class                                            
LAP UD-PL 5 mW up to 3 m 1        
LAP UD-XL 10 mW up to 6 m 2        
LAP UD-XXL 15 mW up to 9 m 2        
LAP UD-XXXL 30 mW up to 12 m 2M        
* standard optics, line length depends on ambient light, height above surface, angle
show allhide

GENERAL DATA

Laser data

Laser type diode
Wavelength 635 nm
Laser colour red
show allhide

Optics data

Divergence 0.5 mrad
show allhide

Electronics data

Operating Voltage DC 4 ... 6 VDC
Power consumption < 200 mA
show allhide

Housing data

Enclosure rating IP 42
Dimensions Length 70 mm × Ø 23 mm (front) / 15 mm (back)
Weight 40 g
Power connector M8, 3-core
show allhide

System data

Application conditions -10 ... +40 °C, 35 - 90 % rel. humidity, non condensing
Output power 5 ... 30 mW
show allhide